DMX Circle PowerLED RGB

Features:
 Tiny size - less than 50mm diameter!
 Current regulated outputs
 Ultra efficient design
 Fully selectable DMX base address
 On-board terminate setting (120 Ohm)
 Data indicator LED
 Built in stand-alone programs available
 USITT DMX512 / 1990 (4µSec) compliant
 Custom builds available

Specifications:

Size: 49.5mm diameter circle (PCB), 9.5mm max. above PCB and 2mm below.

Fixings: 2x 2.5mm holes on 21.35mm radius, 180° apart.

Weight: ~20g.

Power connection: 2x Screw terminals, 3.81mm pitch.

Input voltage: 28Vdc maximum.

Quiescent current: 5mA at 24Vdc (no DMX signal).

DMX connection: 3x Screw terminals, 3.81mm pitch.

DMX input: RS-485 compliant.

Output connection: 3 pairs of solder pads on 0.1” pitch.

Output current: 350mA / 500mA / 700mA regulated.
(must be specified when ordering)

Efficiency: Up to 96%.

PWM Frequency: 100Hz approx.

DMX512: RS485 standard at 250kbps. 8 Data bits, 1 Start bit, 2 Stop bits.

Stand-Alone cross fade programme as standard, other
custom programmes to customer specifications, on request.

DIP Switch Settings:
1= DMX base address (1)
2= DMX base address (2)
3= DMX base address (4)
4= DMX base address (8)
5= DMX base address (16)
6= DMX base address (32)
7= DMX base address (64)
8= DMX base address (128)
9= DMX base address (256)
10= Terminate (on/off)

DMX Addressing:
Firmware version 1.1
Address 0 Sleep mode device can safely remain on DMX bus
Address 1 to 508 Normal DMX function
Address 509 Steps through each output channel sequentially
Address 510 Cross fade pattern, R-G-B-R-G-B-R….
Address 511 All channels on full (lamp test)